Jensen OutdoorPenofin Verde Oil Finish

To prepare Ipe Wood for a UV-protective coat of Penofin® Verde Oil Finish, use Penofin® Pro-Tech Wood Cleaner to remove surface dirt, then rinse off with water.

To brighten and re-establish the pH balance of Ipe wood to best accept the Penofin® Verde Oil Finish, use Penofin® Pro-Tech Wood Brightener, then rinse off with water and allow to dry completely.

Application

• Use Pro-Tech Brightener if the wood is gray or discolored to restore the woods original appearance.

• STIR THOUROUGHLY BEFORE USING. DO NOT add thinning or blending agents.

• Apply Verde to a clean dry surface. Surface must be free of dirt and sawdust build-up. Do not apply when wood is hot to the touch. Minimum temperature is 45 degrees Fahrenheit.

• Brush or spray on using a pump up sprayer equipped with a plastic tip.

• To allow for maximum penetration wait 30 minutes, then use a nap-free shop cloth and wipe the entire surface, removing excess product.

• Surface will be dry to the touch in four hours, and ready for use in 12 hours.

For further instructions, see Jensen Outdoor Care and Maintenance