Maintaining/Weathering Teak Teak furniture requires little, if any, maintenance and can be left outdoors year-round to weather naturally. While the rate of weathering varies depending on climate, moisture and exposure to sun, your furniture will eventually acquire a beautiful silver-gray patina as the surface pigments begin to fade usually within nine months. We recommend that you allow your furniture to weather naturally this way and simply clean it thoroughly once or twice a year with soap and water.
During the weathering process you may notice "checking" or small cracks that appear in the wood. This is perfectly natural, as wood expands and contracts slightly when left outdoors. Checking is cosmetic only and in no way affects the structural integrity of the furniture. A lifting of the grain may occur on the top edges of the arms and legs. The grain will return to a smooth finish after the initial weathering process. Water spots or other discoloration may occur during the weathering process; these will even out with time.
Cleaning First, hose down the furniture with fresh water. Avoid spraying the teak with a high pressure hose, as high pressure can erode the surface of the timber. Next, scrub the wet furniture using a soft bristle brush and a solution of 2/3 cup laundry detergent and 1/4 cup bleach in 1 gallon of warm water. When finished, rinse the entire piece with more fresh water to remove any remaining cleaning solution. This procedure is sufficient for general cleaning. For more difficult stains we recommend using
Kingsley Bate Teak Cleaner. This will remove the silver-gray patina and restore the furniture to a golden brown color. For additional details please review the
Kingsley Bate Care and Maintenance FAQs Sheet.
Kingsley Bate does not recommend oiling teak furniture or the use of oil based products. If done improperly, oiling can cause mildew or irregular coloring and is not covered under warranty. Teak Care Products Teak Protector: If you prefer to keep your teak furniture a golden color, we recommend using
Kingsley Bate Teak Protector. This is a purely cosmetic application. The product will maintain the golden color for a season and can be reapplied as needed. You should wait two weeks before applying the protector to newly assembled furniture. We suggest you try it on a small area of your furniture first, such as the underside of a chair. We will not be responsible if you apply the product to your furniture and are not satisfied, or if instructions on the label are not properly followed.
Teak Cleaner: If your furniture has weathered and you wish to remove the silver-gray patina, we recommend using
Kingsley Bate Teak Cleaner. The cleaner will restore the furniture to a light brown color regardless of how long the piece has been outside. This product requires no heavy scrubbing or polishing and takes approximately thirty minutes per piece to apply.
NOTE: This product will not remove the gray color on furniture that has been treated with our Instant Gray product. Teak Shield: Our Teak Shield product protects wood from food and drink stains. A completely transparent product,
Kingsley Bate Teak Shield makes it difficult for stains from red wine, salad oil, and coffee to penetrate wood, so that fresh spills can be wiped away with a damp cloth. The product is also recommended for impeding mildew growth on furniture used in climates where mildew is prevalent. Teak Shield can be used on clean, naturally weathered wood, or on furniture that has been treated with our Teak Protector or Instant Gray. Apply two or more times per year depending on use and exposure.
Winter Care Kingsley Bate recommends that furniture with stainless steel accents be stored for the winter in climates exposed to snow and freezing temperatures. Furniture must be stored in an upright position to allow for proper water drainage. Storing furniture upside-down may cause water to accumulate and freeze inside the frame, causing structural damage. Always thoroughly clean your furniture before placing in storage. The best place to store your furniture is a dry garage, garden shed, or basement.
Cleaning Stainless Steel The recommended method for cleaning depends on the type of finish:
For the Standard Stainless Steel Finish: Using fresh water, rinse the frame thoroughly at a high hose pressure. Be careful to avoid any teak details on the furniture as the high pressure can erode the surface of the timber.
For more thorough cleaning, wash the stainless steel with mild detergent and warm water using a soft cloth or sponge. Always wipe with the directional grain of the steel, not across it. After washing, rinse with fresh water and dry thoroughly.
For finger prints or smudges, you may wish to use a stainless steel cleaner. Always read the manufacturer's instructions carefully before applying a stainless steel cleaning product. For more stubborn cleaning or brown surface spots, follow the instructions above, replacing the cloth or sponge with a fine grit non-metallic abrasive pad such as Scotch-Brite. Never use abrasive cleaners, steel wool pads, highly abrasive cloths, or an industrial pressure washer.
For the Electropolished Standard Stainless Steel Finish: Using fresh water, rinse the frame thoroughly at a high hose pressure. Be careful to avoid any teak details on the furniture as the high pressure can erode the surface of the timber.
For more thorough cleaning, wash the stainless steel with mild detergent and warm water using a soft cloth or sponge. After washing, rinse with fresh water and dry thoroughly.
For finger prints, smudges, or brown surface spots, you may wish to use a stainless steel cleaner. Always read the manufacturer's instructions carefully before applying a cleaning product. Do not use any pads, brushes or abrasive materials on the electropolished surface. Extra care should be used to avoid scratching the finish, as doing so can make the steel more susceptible to corrosion.
Cleaning Slings Kingsley-Bate slings are made of 100% vinyl-coated polyester, an extremely durable, fade resistant, and easy to care for fabric. Regular maintenance will help extend the life of the fabric. We recommend cleaning the fabric twice yearly for moderate use, or more often for heavy-use applications. To clean fabric slings, prepare a solution using 1 tbsp. liquid dish detergent and 2 tbsp. bleach mixed in 1 gallon of fresh warm water. Clean the fabric using a sponge or soft cloth dipped in the solution. Be careful to avoid getting this solution on the teak or stainless steel furniture frame. After cleaning, rinse the fabric thoroughly with fresh water and allow it to air dry.
For more stubborn stains, use the following treatments: - Suntan lotion, oils, or grease: Rubbing alcohol
- Mildew: Use strong liquid detergent with warm water and chlorine bleach.
- Beer and coffee: Use strong liquid detergent with warm water and white vinegar.
- Berry juices, wine, or blood: Use strong liquid detergent, warm water and ammonia.
You should avoid putting your sling fabric in direct contact with oil-based products such as suntan lotion, which may cause the fabric to discolor or age more rapidly. If direct contact occurs, clean the fabric promptly to remove any lotion or oil residue. Furniture Covers Furniture covers should be cleaned regularly before environmental deposits (dirt, etc.) are allowed to accumulate and become embedded in the fabric. We recommend spot cleaning furniture covers. Start by brushing off any loose dirt/debris, then clean using a sponge, fresh water, and mild soap.
