ShademakerPolaris 10' x 13' Rectangular Aluminum Commercial Cantilever Patio Umbrella

Due to cutting requirements, striped fabrics are only available in sets of two. Click here to view these fabrics or call the showroom for additional details.

If using a free-standing base, wind guidelines change from moderate to strong winds to light winds only. 

When open, the Shademaker 10' x 13' Rectangular Polaris Cantilever offset umbrella provides protecting shade for you and your guests. When closed, it folds back completely out of the way and occupies just a small footprint. Now with new designed modern hub and fittings, this tilting and fully rotating umbrella is made to commercial standards and features an all-aluminum frame with commercial awning grade and furniture grade fabric options that are mold and mildew resistant. Commercial grade canopy fasteners adding durability and design. The available mount kits include concrete, in-ground as well as free-standing bases. Minimum Base Weight for 10' x 13' is 550 lbs. This umbrella is great for areas with wind speeds of up to 28 mph when permanently mounted.

All Shademaker Umbrellas include the Internal Mast stem for installation and a Fabric Protective Cover.

All fabrics are made of a solution-dyed yarn, which means the pigments are saturated through the entire thread and are not a print on the surface of the fabric. All fabrics are fade, stain, mold and mildew resistant and are easily cleanable. Shademaker offers both acrylic and polyester fabrics for their umbrella canopies:

Frame finish shown is Arctic White. Click here for additional frame finishes. Minimum order quantities and longer lead times may apply.

Installation Options

• CONCRETE MOUNT KIT - This kit includes a base plate, four (4) stem bolts, and one (1) allen wrench.
• IN-GROUND MOUNT KIT - This kit includes in-ground fitting.
• FREE STANDING BASE - You may opt to use a free standing base for your umbrella. Minimum Base Weight: 9' 9" - 450 lbs., 11' 5" - 550 lbs., 13' 1" - 750 lbs. Stone weights needed for steel base frame are not included.

• Hose mast and frame with water periodically, more often if installation is in a salty or industrial environment.
• Inspect the installation fitting on a regular basis and tighten if necessary.
• Lubricate the track and slider car mechanism as needed to enhance the ease of operation. We recommend using DuPont Dry Film Lubrication products.

• Clean up spills and stains right away. Spills can be removed by using a clean absorbent cloth.
• For general maintenance, use a soft brush to remove dust and dry soil. Wash down with clean, warm water (i.e. garden hose) every so often to avoid dirt becoming engrained. Allow the fabric to air dry before closing the canopy.
• If a thorough cleaning is necessary, sponge over the fabric using a mild soap solution (2% solution). Rinse well with plenty of water to remove all soap residues.
• Never use detergents, cleaning fluids or solvents. Grease and oil stains may be removed by using turpentine or similar with an absorbent cloth.
• We recommend giving the canopy a good cleaning on a more frequent basis if installed in a location where the canopy is likely to become soiled.
• Use protective canopy cover during storage.

• While Shademaker umbrellas are made to withstand some wind - it is recommended that the umbrellas always be lowered during windy conditions. If it is too windy to enjoy your umbrella, then the umbrella should be closed. Please remove the umbrella during extreme weather conditions to avoid damage that could be caused by flying debris.
• Note: Wind damage (or any damage caused by acts of nature) is never covered under warranty.
• Sufficient base weight must be used to secure umbrellas at all times. Please see our base chart for minimum requirements for free standing base weight. Mounting your umbrella to an existing deck or patio is always the preferred method of securing your umbrella and is recommended above all other methods. We recommend a licensed contractor to secure your Shademaker umbrellas.