Winter Care
Kingsley Bate recommends that furniture with stainless steel accents be stored for the winter in climates exposed to snow and freezing temperatures. Furniture must be stored in an upright position to allow for proper water drainage. Storing furniture upside-down may cause water to accumulate and freeze inside the frame, causing structural damage. Always thoroughly clean your furniture before placing in storage. The best place to store your furniture is a dry garage, garden shed, or basement.

Cleaning Stainless Steel
The recommended method for cleaning depends on the type of finish:

For the Standard Stainless Steel Finish:
Using fresh water, rinse the frame thoroughly at a high hose pressure. Be careful to avoid any teak details on the furniture as the high pressure can erode the surface of the timber.

For more thorough cleaning, wash the stainless steel with mild detergent and warm water using a soft cloth or sponge. Always wipe with the directional grain of the steel, not across it. After washing, rinse with fresh water and dry thoroughly.

For finger prints or smudges, you may wish to use a stainless steel cleaner. Always read the manufacturer's instructions carefully before applying a stainless steel cleaning product. For more stubborn cleaning or brown surface spots, follow the instructions above, replacing the cloth or sponge with a fine grit non-metallic abrasive pad such as Scotch-Brite. Never use abrasive cleaners, steel wool pads, highly abrasive cloths, or an industrial pressure washer.

For the Electropolished Standard Stainless Steel Finish:
Using fresh water, rinse the frame thoroughly at a high hose pressure. Be careful to avoid any teak details on the furniture as the high pressure can erode the surface of the timber.

For more thorough cleaning, wash the stainless steel with mild detergent and warm water using a soft cloth or sponge. After washing, rinse with fresh water and dry thoroughly.

For finger prints, smudges, or brown surface spots, you may wish to use a stainless steel cleaner. Always read the manufacturer's instructions carefully before applying a cleaning product. Do not use any pads, brushes or abrasive materials on the electropolished surface. Extra care should be used to avoid scratching the finish, as doing so can make the steel more susceptible to corrosion.

Cleaning Cushions
Kingsley Bate cushions are made with either Sunbrella or Outdura fabrics, a 100% solution-dyed acrylic. The fabric should be cleaned regularly before environmental deposits such as dirt, etc., are allowed to accumulate and become embedded.

Kingsley Bate strongly recommends that you do not remove the fill from your cushions when cleaning the cushion fabric. Instead, clean the cushions with the fill in place. Most cushions are 'stuffed' using specialized machinery, and it is not always possible to re-stuff the cushions by hand and achieve a professional, finished appearance.

To clean the fabric, simply brush off any loose dirt, and then clean briskly with a sponge using fresh water and a mild natural soap (Woolite is acceptable). Water temperature should be no more than 100 degree F (37 degree C), as acrylic fiber is heat sensitive at high temperatures. Do not subject the fabric to excessive heat as it will shrink. Do not steam press, iron, or dry in electric or gas dryers.

Sunbrella and Outdura Fabrics are treated with a fluorocarbon finish that acts as a sealant, making it resistant to water and stains. If you use liquid detergent instead of a natural soap to clean your cushions, it may be necessary to reapply the water repellent treatment to the fabric. We recommend using 303 Hi Tech Fabric Guard or a similar product.

If your cushion becomes saturated with water, unzip the cushion and stand it on its edge in a dry, sunny location. The zipper-side should be facing down to allow the water to drain through the opening. Cushions will typically dry in 24-48 hours depending on the level of saturation and the weather conditions during the drying process.

When cushions are not being used, you may also wish to stand them on edge within the furniture frame. Doing so will reduce the surface area exposed to the rain and allow for faster drying.

Avoid putting the fabric in direct contact with oil-based products, which may cause the fabric to age more rapidly. If direct contact with an oil-based product occurs, clean the fabric promptly.

Furniture Covers
Furniture covers should be cleaned regularly before environmental deposits (dirt, etc.) are allowed to accumulate and become embedded in the fabric. We recommend spot cleaning furniture covers. Start by brushing off any loose dirt/debris, then clean using a sponge, fresh water, and mild soap.